Everything below concerns Creatinine. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Updated 2026-07-11. Numbers and descriptions here follow the published literature rather than marketing material.
Creatine monohydrate is a crystalline organic compound formed from creatine and water in a one-to-one ratio. It belongs to the guanidino family and contains a methylated guanidine group attached to an acetate-like chain. The solid is commonly described as a white, odorless powder with a mildly bitter taste. Its molecular formula is C4H11N3O3·H2O, and the hydrated form is the most widely traded grade. The compound occurs naturally in vertebrate muscle and brain tissue, where it participates in rapid energy buffering.
In aqueous solution, creatine monohydrate exists mainly as a zwitterion, carrying both a positive guanidinium charge and a negative carboxylate charge. This charge separation raises water solubility relative to many neutral organic solids and helps explain its behavior in analytical separations. The monohydrate can lose its water of crystallization under sustained heat or low humidity, converting toward anhydrous creatine. Such transitions matter for mass balance calculations because the hydrate contributes water mass that is not part of the active creatine molecule.
In dry solid form, creatine monohydrate is relatively stable when protected from moisture and heat. The crystal lattice includes water, and exposure to high humidity can cause caking or gradual changes in powder flow. Elevated temperatures may accelerate decomposition, particularly if moisture is present. Studies generally report that sealed, dry material retains acceptable purity for extended periods, although exact shelf life depends on packaging and storage conditions. Light exposure is not usually considered a major factor for this compound.
In aqueous solution, creatine monohydrate undergoes a slow conversion to creatinine, a cyclized degradation product. This reaction is pH- and temperature-dependent, and it proceeds faster in warm or alkaline conditions. Because the conversion is gradual, analytical measurements of creatine in solution must account for time and storage history. The equilibrium favors creatinine more strongly at higher temperatures, which is relevant to sample handling in laboratories and to beverage formulations. Refrigeration slows but does not entirely stop this process.
Quality assessment of creatine monohydrate typically uses high-performance liquid chromatography to separate creatine from creatinine and other impurities. Other methods include nuclear magnetic resonance spectroscopy, titration, and infrared spectroscopy for identity confirmation. Purity is often reported as a percentage of the labeled compound on a dry basis, while moisture content is measured separately. Because different analytical methods have different selectivity, comparing purity values across sources requires attention to the method and sample preparation.
| Property | Value | Notes |
|---|---|---|
| Chemical formula | C4H11N3O3·H2O | Hydrated form includes one water molecule per creatine unit. |
| Molar mass | 149.15 g/mol | Calculated for the monohydrate form. |
| Appearance | White crystalline powder | Common commercial grade is odorless or nearly odorless. |
| Solubility in water | Moderately soluble | Solubility increases with temperature and depends on pH. |
| Common synonyms | Creatine hydrate; N-methylguanidinoacetic acid | Monohydrate distinguishes it from anhydrous creatine. |
Creatine monohydrate is a crystalline compound formed when one molecule of creatine associates with one molecule of water in the solid lattice. Its molecular formula is C4H11N3O3, and its molar mass is about 149.15 grams per mole. The material appears as a white, odorless powder that dissolves sparingly in water at room temperature. The monohydrate designation distinguishes it from anhydrous creatine, which lacks the bound water and has a lower molar mass. This hydrate is the most common commercial form of creatine used in nutritional and research settings.
Creatine is synthesized endogenously in humans, mainly in the liver, kidney, and pancreas, from the amino acids arginine, glycine, and methionine. Skeletal muscle stores much of the body's creatine, where it participates in the phosphocreatine system that buffers adenosine triphosphate during short, intense contractions. Dietary sources include meat and fish, so omnivorous diets provide additional creatine beyond endogenous production. Supplemental creatine monohydrate supplies the same molecule found in food and tissues, not a distinct drug or hormone. Research interest centers on its role in cellular energy transfer and its effects on muscle and other tissues.
The compound was identified in the nineteenth century after chemists isolated a nitrogenous substance from meat extracts. Later work established its role in muscle energy metabolism and its conversion to phosphocreatine. Chemical synthesis of creatine followed, and industrial production made the monohydrate widely available as a purified powder. Interest expanded in the late twentieth century when researchers began studying creatine supplementation and muscle physiology. Historical accounts sometimes differ on exact dates and attributions, but the broad sequence from tissue extracts to synthetic production is well documented.
In the body, creatine is obtained from dietary meat and fish and is also synthesized from arginine, glycine, and methionine. Muscle stores creatine and phosphocreatine, which participate in the rapid regeneration of adenosine triphosphate during short, intense activity. The monohydrate form is used in research because it is chemically defined, stable as a dry solid, and relatively inexpensive to produce. Questions remain about whether other creatine forms offer meaningful advantages in absorption or tissue retention, and findings vary across studies and populations.
Quality control for creatine monohydrate begins with identity confirmation and assay determination. Laboratories commonly use high-performance liquid chromatography with ultraviolet detection, often after derivatization or using a suitable column, to quantify creatine. Karl Fischer titration measures water content, which helps verify the monohydrate stoichiometry. Additional tests screen for heavy metals, residual solvents, and microbial contamination depending on the intended use. These tests establish composition and purity rather than biological effect.
Stability studies examine how creatine monohydrate changes under controlled temperature and humidity. The solid is generally stable when kept dry, but moisture can promote hydrolysis to creatinine, especially in solution or at elevated temperatures. Color, odor, and assay values are monitored over time to detect degradation. Because degradation pathways depend on storage conditions, shelf-life claims should specify the tested packaging, temperature, and humidity. Open questions remain about the long-term behavior of different crystal habits and particle sizes.
Regulatory treatment of creatine monohydrate varies by country and intended use. In some jurisdictions it is sold as a dietary supplement, while in others it may be treated as a food ingredient or a pharmaceutical raw material. Pharmacopeial monographs, where available, define identification, assay limits, and impurity thresholds. Manufacturers often follow these monographs or internal specifications to ensure batch-to-batch consistency. Analytical method validation is important because different methods can yield different apparent purity values if sample preparation or detection conditions are not controlled.
Solid creatine monohydrate is generally stable when kept dry and protected from extremes of heat and humidity. In the presence of moisture, it can gradually convert to creatinine, a cyclic dehydration product that has little value for phosphocreatine synthesis. Elevated temperatures and acidic conditions accelerate this conversion in solution. Because the reaction is slow in cool, dry storage, typical shelf lives are measured in years rather than weeks. Packaging that limits moisture and oxygen exposure helps maintain purity.
Recommended storage usually involves a sealed container kept at room temperature, away from direct sunlight and moisture. High humidity can cause caking, which changes flow properties and may complicate accurate weighing. Repeated opening of containers exposes the powder to air and moisture, so smaller aliquots can reduce handling effects. Storage temperature ranges are not absolute requirements; they reflect conditions that slow degradation and preserve consistent physical characteristics. Clean, dry tools help prevent contamination during sampling.
Identity and purity are commonly assessed by high-performance liquid chromatography, often with ultraviolet detection, and by spectroscopic techniques such as infrared or nuclear magnetic resonance. These methods can distinguish creatine from creatinine and detect related impurities. Moisture content may be measured by Karl Fischer titration or loss on drying. Particle size, bulk density, and heavy metal limits are additional quality parameters. Not every product is tested by every method, so specifications depend on the intended use and regulatory framework.
A particular challenge in analysing AlphaFold models is distinguishing genuine topology from structural prediction artefacts. A high confidence score does not by itself guarantee that a predicted chain crossing is correct, and incorrect modelling of termini or flexible regions may change the calculated topology. AlphaKnot 2.0 therefore provides several measures intended to help evaluate a predicted knot, including the pLDDT values of the complete chain and knot core, the confidence near the boundaries of the knot core, and detection of unusually close contacts between Cα atoms. Users can also compare AlphaFold predictions with independently generated ESMFold models for shorter proteins. Because automated analysis at the scale of the AlphaFold database cannot be manually verified structure by structure, AlphaKnot 2.0 introduced a user annotation system. Database entries can be assessed by users as a knot, artifact, or unsure, allowing potentially incorrect predictions to be flagged for further consideration.
Amitabha Chattopadhyay is an Indian scientist working in the areas of membrane and receptor biology and biophysics . He is presently a CSIR Bhatnagar Fellow at the Center for Cellular and Molecular Biology and served as the founding dean of biological sciences at the Academy of Scientific and Innovative Research (AcSIR). In addition, he is a distinguished visiting professor at the Indian Institute of Technology Bombay, adjunct professor at the Jawaharlal Nehru University (New Delhi), Tata Institute of Fundamental Research, Indian Institute of Science Education and Research (Kolkata), Swinburne University of Technology (Australia), and honorary professor at the Jawaharlal Nehru Centre for Advanced Scientific Research (Bangalore). He was elected a Fellow of the Royal Society of Chemistry in 2013 and Royal Society of Biology in 2017. Chattopadhyay has authored more than 300 research papers and has an h-index of 65. In 2016, Chattopadhyay won The World Academy of Sciences in Biology for his seminal contribution in understanding the role of membrane cholesterol in the organization and function in healthy and diseased conditions.
MIPOL1 (Mirror Image Polydactyly 1), also known as CCDC193 (Coiled-coil domain containing 193), is a protein that in humans is encoded by the MIPOL1 gene. Mutation of this gene is associated with mirror-image polydactyly (also known as Laurin-Sandrow syndrome.) in humans, which is a rare genetic condition characterized by mirror-image duplication of digits. MIPOL1 is also known as CCDC193 (Coiled-coil domain containing 193). The MIPOL1 gene is located at 14q13.3-q21.1 on the plus strand, spanning base pairs 37,197,888 to 37,579,207 (in the human GRCh38 primary assembly, length: 381,320 base pairs), consisting of 15 exons and 11 introns. Some notable genes in its neighborhood include SLC25A21 (mutation of this gene causes synpolydactyly) and FOXA1. MIPOL1 has at least 15 known splice isoforms produced by alternative splicing. The unmodified MIPOL1 protein isoform 1 in humans has an isoelectric point of 5.6 and molecular weight 51.5 kDa. Relative to other human proteins, MIPOL1 consists of unusually low amounts of Proline and Glycine and higher amounts of Glutamic acid and Glutamine.
Sources: en.wikipedia.org
On-line mass spectrometry was develop to solve some of the limitations and problem that develop from off-line analysis, such as evaporation and chemical reactions of particles in the filters during long analysis time. On-line Mass spectrometry solves these problems through the collection and analysis of aerosol particles in real time. On-line instruments are very portable and allow for spatial variability to be examined. These portable instruments can be put on many different platforms such as boats, planes, and mobile platforms (e.g. car trailers). An example of this is in the picture at the beginning with the instrumentation attached to an aircraft. Like off-line, on-line mass spectrometry has many different type of instruments, which can be broken up into two types; instruments that measures the chemistry of the particle ensemble (bulk measurement) and those that measure the chemistry of individual particles (single-particle measurement). Thus based on analytical need different instrumentation is used in analysis of the aerosol particles.
The word "aptamer" is a neologism coined by Andrew D. Ellington and Jack Szostak in their first publication on the topic. They did not provide a precise definition, stating "We have termed these individual RNA sequences 'aptamers', from the Latin aptus, to fit." The word itself, however, derives from the Greek word ἅπτω, to connect or fit (as used by Homer (c. 8th century BC)) and μέρος, a component of something larger. A typical aptamer is a synthetically generated ligand exploiting the combinatorial diversity of DNA, RNA, XNA, or peptide to achieve strong, specific binding for a particular target molecule or family of target molecules. Aptamers are occasionally classified as "chemical antibodies" or "antibody mimics". However, most aptamers are small, with a molecular weight of 6-30 kDa, in contrast to the 150 kDa size of antibodies, and contain one binding site rather than the two matching antigen binding regions of a typical antibody.
Aspartate transaminase, as with all transaminases, operates via dual substrate recognition; that is, it is able to recognize and selectively bind two amino acids (Asp and Glu) with different side-chains. In either case, the transaminase reaction consists of two similar half-reactions that constitute what is referred to as a ping-pong mechanism. In the first half-reaction, amino acid 1 (e.g., L-Asp) reacts with the enzyme-PLP complex to generate ketoacid 1 (oxaloacetate) and the modified enzyme-PMP. In the second half-reaction, ketoacid 2 (α-ketoglutarate) reacts with enzyme-PMP to produce amino acid 2 (L-Glu), regenerating the original enzyme-PLP in the process. Formation of a racemic product (D-Glu) is very rare. The specific steps for the half-reaction of enzyme-PLP + aspartate ⇌ {\displaystyle \rightleftharpoons } enzyme-PMP + oxaloacetate are as follows (see figure); the other half-reaction (not shown) proceeds in the reverse manner, with α-ketoglutarate as the substrate.
Sources: en.wikipedia.org
In common usage, yes, but technically creatine monohydrate is one specific hydrated salt form. Other creatine forms exist and differ in composition and properties. The monohydrate is the most studied and most widely available grade.
Yes. Each creatine molecule in the crystal is associated with one water molecule. That water contributes to the total mass but is not part of the creatine molecule itself. Heating or drying can remove some or all of this water.
It occurs naturally in meat and fish, and the human body also makes and stores creatine. Food sources provide varying amounts depending on the type and preparation. The compound is not considered an essential dietary nutrient for adults because the body can synthesize it.
Dry, sealed creatine monohydrate can remain stable for years, but storage conditions affect its shelf life. Moisture, heat, and repeated opening of containers can reduce quality over time.