The short version of GRF(1-29) fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2025-12-24 and is reviewed periodically as new material appears.
Purity is most often assessed by reversed-phase high-performance liquid chromatography, reported as a percentage of total peak area. Identity is confirmed by mass spectrometry, which yields a molecular ion consistent with the expected sequence. Amino acid analysis and peptide mapping provide additional characterization. Reported purity values are method-dependent, so figures from different laboratories are not always directly comparable without details of column, gradient, and detection wavelength.
Peptide degradation proceeds mainly through hydrolysis, oxidation of methionine, and deamidation of asparagine or glutamine residues. The maleimide group on the albumin-binding variant can also react with thiols or hydrolyze in aqueous media. Because these pathways accelerate with temperature and pH extremes, handling conditions strongly influence measured stability. Stability data in the public literature are limited and often generated under differing conditions, so general statements about shelf life should be read as approximate.
Research material is normally supplied as a freeze-dried powder in sealed vials. In that state the peptide is comparatively robust, but prolonged exposure to warmth, moisture, or light accelerates degradation. Storage at minus twenty degrees Celsius or lower, with desiccant and protection from light, is the commonly described practice. Vials should be allowed to reach room temperature before opening to limit condensation on the powder. Moisture uptake during handling is a recognized source of variability in later measurements.
CJC-1295 is a synthetic peptide analog of growth hormone-releasing hormone, constructed on the 29-amino-acid fragment designated GRF(1-29). The name began as an internal development code during the 1990s and later spread through research supply catalogs and discussion forums. The molecule does not occur in nature; its sequence is engineered rather than isolated from tissue. Two related compounds are sold under this single label, and they differ by one appended chemical group that strongly influences how long the peptide remains in circulation.
The dividing feature between the two forms is a maleimide-based drug affinity complex, abbreviated DAC. In the DAC-bearing version, a linker attaches the peptide to serum albumin after administration, and that association slows removal from plasma. The version lacking DAC appears in catalogs as MOD GRF(1-29) or tetrasubstituted GRF(1-29). Because informal writing treats both as one item, comparisons drawn from such sources routinely blend measurements taken from two molecules with substantially different behavior.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white lyophilized powder | Visual descriptor; not a measure of purity |
| Solubility class | Freely soluble in water | Aqueous dissolution may require gentle mixing |
| Typical storage (powder) | −20 °C or below, desiccated | Protect from light and ambient moisture |
| Typical storage (solution) | 2–8 °C, short term | Freeze aliquots where longer holding is needed |
| Purity assessment | Reversed-phase HPLC, area percent | Values depend on column, gradient, and detection wavelength |
The peptide backbone corresponds to GRF(1-29), the first 29 residues of native growth hormone-releasing hormone, which retains most of the receptor-activating activity of the full-length molecule. Four substitutions distinguish the analog from the natural sequence: D-alanine at position 2, glutamine at position 8, alanine at position 15, and leucine at position 27. These changes slow cleavage by dipeptidyl peptidase IV, the enzyme that degrades native hormone in plasma within minutes. The outcome is improved enzymatic stability combined with a still brief residence time when no additional modification is present.
Naming in this area is inconsistent, and readers should treat product labels with care. In much of the literature and in vendor catalogs, the unqualified term refers to the albumin-binding version, while the version lacking the DAC group appears as modified GRF(1-29), mod GRF(1-29), or the same name with a without-DAC qualifier. Because one abbreviation has been applied to both materials, the only reliable way to identify a sample is to check the stated sequence and the presence of the linker.
Laboratory handling centers on minimizing exposure to water, heat and oxygen before use. Working solutions are typically prepared in sterile water or a mild buffer, and any residual particulate matter is removed by filtration. When the powder dissolves slowly, a small proportion of acetonitrile or dilute acetic acid is sometimes added as a co-solvent. Containers are kept sealed and desiccated between uses. Records of lot number, reconstitution date and storage conditions support later comparison of results across experiments.
Identity and purity are established with reversed phase high performance liquid chromatography coupled to mass spectrometry. The chromatographic step separates the target peptide from truncated sequences and deletion products, while the mass measurement confirms the expected molecular weight to within a fraction of a dalton. Because the two common variants differ by the presence of the linker, mass alone can distinguish them in the unconjugated state. Amino acid analysis and peptide mapping are used when sequence level confirmation is required.
Lyophilized material is generally stable for extended periods when held at minus twenty degrees Celsius or below and protected from moisture and light. In solution the peptide is more labile; bond hydrolysis, aggregation and oxidation of susceptible residues all proceed faster at ambient temperature. Repeated freeze and thaw cycles should be avoided because they promote clumping and loss of soluble material. The conjugated variant adds a further consideration, since the maleimide group can hydrolyze in aqueous buffer and lose its ability to react with albumin.
Stability depends heavily on physical state. A lyophilized powder kept dry, desiccated, and shielded from light typically holds its integrity for months to years at minus twenty degrees Celsius, and longer at minus eighty. Once dissolved, the peptide becomes far more vulnerable, since peptide bond hydrolysis, oxidation of susceptible residues, and aggregation all proceed faster in solution. Buffers near neutral pH are generally gentler than strongly acidic or alkaline conditions. Repeated freeze-thaw cycles and exposure to air-liquid interfaces during vigorous mixing cause losses that are easy to overlook.
Verification matters because research peptides vary widely in quality. A certificate of analysis is only as reliable as the method behind it, and a single chromatographic trace reveals little about counter-ions, residual solvents, or water content. Independent laboratories commonly pair mass confirmation with chromatographic purity and, where relevant, quantify water along with acetate or trifluoroacetate content. Reported purity figures are not standardized across suppliers, so a stated value such as ninety-eight percent is not directly comparable unless the analytical method, column, and detection wavelength accompany it.
The effects of PKA results from its ability to phosphorylate serine and threonine residues on many cellular proteins, especially transcription factor cAMP response element binding protein (CREB). cAMP/PKA/CREB axis mediates the inhibition of TNF-alpha release. The killing of phagocytosed bacteria by AMs is dependent upon several distinct microbicidal mechanisms, like the reduced NADPH oxidase-mediated release of ROI. ROI generation by NADPH oxidase is an important bactericidal mechanism after FcR-mediated phagocytosis. PGE2 activates both Gs-coupled EP2 and EP4 receptors by ligation, stimulating cAMP production and subsequent activation of downstream cAMP effectors, PKA and Epac-1; both which in turn impair the phosphorylation and phagosomal membrane translocation of NADPH oxidase component, p47phox, thereby inhibiting the respiratory burst.
=== Related terminology === The rate of a reaction is the concentration of substrate disappearing (or product produced) per unit time (mol L−1 s−1). The % purity is 100% × (specific activity of enzyme sample / specific activity of pure enzyme). The impure sample has lower specific activity because some of the mass is not actually enzyme. If the specific activity of 100% pure enzyme is known, then an impure sample will have a lower specific activity, allowing purity to be calculated and then getting a clear result.
== See also == Aptamer – Oligonucleotide or peptide molecules that bind specific targets Deoxyribozyme – DNA oligonucleotides that can perform a specific chemical reaction Anti-thrombin aptamers – Oligonucleotides which recognize the exosites of human thrombin Bacterial one-hybrid system – Method for identifying the sequence-specific target site of a DNA-binding domain SMiLE-Seq – Similar method using a microfluidic device loaded with “bait” transcription factors and DNA molecules
Sources: en.wikipedia.org
signaling PRRs that activate gene transcriptional mechanisms that lead to cellular activation, endocytic PRRs that function in pathogen binding and phagocytosis, and secreted PRRs that usually function as opsonins or activators of complement. The recognition and clearance of invading microorganisms occurs through both opsonin-dependent and opsonin–independent pathways. The molecular mechanisms facilitating opsonin-dependent phagocytosis are different for specific opsonin/receptor pairs. For example, phagocytosis of IgG-opsonized pathogens occurs through the Fcγ receptors (FcγR), and involves phagocyte extensions around the microbe, resulting in the production of pro-inflammatory mediators. Conversely, complement receptor-mediated pathogen ingestion occurs without observable membrane extensions (particles just sink into the cell) and does not generally results in an inflammatory mediator response. Following internalization, the microbe is enclosed in a vesicular phagosome which then undergoes fusion with primary or secondary lysosomes, forming a phagolysosome. There are various mechanisms that lead to intracellular killing; there are oxidative processes, and others independent of the oxidative metabolism. The former involves the activation of membrane enzyme systems that lead to a stimulation of oxygen uptake (known as the respiratory burst), and its reduction to reactive oxygen intermediates (ROIs), molecular species that are highly toxic for microorganisms.
Immune-mediated causes could include transient factors as in Mycoplasma pneumoniae infection (cold agglutinin disease) or permanent factors as in autoimmune diseases like autoimmune hemolytic anemia (itself more common in diseases such as systemic lupus erythematosus, rheumatoid arthritis, Hodgkin's lymphoma, and chronic lymphocytic leukemia). Spur cell hemolytic anemia Any of the causes of hypersplenism (increased activity of the spleen), such as portal hypertension. Acquired hemolytic anemia is also encountered in burns and as a result of certain infections (e.g. malaria). Lead poisoning or poisoning by arsine or stibine causes non-immune hemolytic anemia. Runners can develop hemolytic anemia due to "footstrike hemolysis", the destruction of red blood cells in feet at foot impact. Low-grade hemolytic anemia occurs in 70% of prosthetic heart valve recipients, and severe hemolytic anemia occurs in 3%.
GoldSrc (pronounced "gold source", formerly the Half-Life Engine) is a proprietary game engine developed by Valve. At its core, GoldSrc is a heavily modified version of id Software's Quake engine. It made its debut in 1998 with Half-Life and powered future games developed by or with oversight from Valve, including Half-Life's expansions, Day of Defeat and games in the Counter-Strike series. GoldSrc was succeeded by the Source engine with the releases of Half-Life: Source, Half-Life 2, and Counter-Strike: Source in 2004.
MG F / MG TF, a 1995 mid-engined, rear wheel drive roadster manufactured by the Rover Group Machine Gun Fellatio, an Australian alternative band Magnesium fluoride (chemical formula MgF2) Malagasy franc, the former currency of Madagascar in ISO 4217 code Mechano growth factor, a peptide hormone produced in muscles in response to training, considered an isoform of IGF-1 Moment-generating function, in probability and statistics .mgf, (for Mascot generic format) a data file format used by Mascot mass spectrometry software Mask generation function, a function generating an arbitrary number of bits for a given input (for example MGF1 from PKCS 1)
Sources: en.wikipedia.org
Cool, dark, and dry conditions are standard, with storage at minus twenty degrees Celsius or below. Desiccant and sealed vials limit moisture uptake. Repeated warming and cooling of the container is generally avoided.
There is no single agreed limit, and laboratory practice varies widely. Refrigeration slows degradation, and freezing aliquots is often described for longer holding. Any visible cloudiness or precipitate indicates the solution should be discarded.
Mass spectrometry provides the most direct confirmation through molecular mass. Reversed-phase chromatography supports purity assessment, and peptide mapping or amino acid analysis can corroborate sequence. No single method establishes both purity and identity on its own.
No. It is a laboratory-synthesized analog built on a fragment of the natural hormone. The natural peptide is shorter-lived and lacks the stabilizing substitutions found in the synthetic version.